Model: DMBD
FLeX Series 3-way, solenoid-operated directional spool valve - 3000 psi (210 bar)
Cavity: T-150A | Capacity:
Technical specifications
This FLeX Series solenoid-operated 3-way, 2-position cartridge is a direct-acting, balanced spool directional valve.
- This valve is direct actuated and requires no minimum hydraulic pressure for operation.
- Designed and tested to 10-million operational cycles at full-rated pressure.
- Exceeds new NFPA test standard T2.6.1 R2014 for fatigue and burst pressure ratings.
- Designed using CFD simulation for optimized geometries.
- All configurations of this valve include zinc-nickel plating as standard for 1000-hour salt fog protection.
- Coil connector options offer ratings up to IP69K. See individual coil product pages for details.
- A FULL DATA SHEET is available for this model using the link at the top of the page.
- This valve utilizes a wet armature design. This means that the working fluid surrounds the armature and is exposed to the heat generated by the coil. This can be a factor if the coil is energized for long periods of time. Some fluids, notably water/glycol mixtures, break down at these temperatures over time and form varnishes that will affect the function of the cartridge.
- A wide variety of coil termination and voltage options are available, with and without surge protection. See the CONFIGURATION section.
- Incorporates the Sun floating style construction to minimize the possibility of internal parts binding due to excessive installation torque and/or cavity/cartridge machining variations.
- Cavity
- Series
- Capacity4 gpm
- Maximum Operating Pressure3000 psi
- Typical Valve Leakage at 110 SUS (24 cSt) from port 1 to port 33 in³/min.@3000 psi
- Response Time - Typical50 ms
- Switching Frequency15,000 max. cycles/hr
- Solenoid Tube Diameter.63 in.
- Valve Hex Size3/4 in.
- Valve Installation Torque25 - 30 lbf ft
- Model Weight.65 lb
- Seal and nut kit - Coil
- Seal kit - Cartridge
- Seal kit - Cartridge
What parts of the Sun cartridge valve are field serviceable?
What is the difference between nominal and maximum flow capacity?
Do FLeX valves utilize a floating nose design?
Is the FLeX program available in QuickDesign SmartConnect?
How big is a drop of hydraulic oil?
Direct acting or pilot operated - what do I use?
- Please verify cartridge clearance requirements when choosing a Sun manifold. Different valve controls and coils require different clearances.
- An additional 2.00 inches (50,8 mm) beyond the valve extension is needed for coil installation and removal.
Highlights
Technical Tips
Technical Information