2-port energy harvester valve

Cavity: T-16A

Model

EVECXX

Control

Functional Setting Range

Where to buy

See CAD Files tab below to request images.

Technical features

This valve is a 2 port cartridge designed to convert hydraulic power from your application into electrical power. The valve accepts flow from Port 1 to Port 2 and outputs a 3-phase AC voltage signal.

Power cable with mating connector is required (not included).
The valve exhibits up to 6 drops per hour of internal leakage into the electronics housing. The auxiliary drain port must be gravity fed and therefore remain at atmospheric pressure to prevent submersion of the electronics.
Valve must be installed in an upright or horizontal orientation. When installed horizontally, the collar should be positioned so that the drain is oriented downward.
This product can handle a maximum of 200 PSI (14 bar) at port 2 and is designed to harvest energy from fluid destined to return to tank.
Higher electrical loads and lower Port 2 pressure have a positive effect in reducing leakage.
In addition to elevated leakage, higher than rated pressures at Port 2 result in a reduction in the power output.
The electrical output is unregulated. Most applications will require external rectification/regulation.
Meets new NFPA test standard T2.6.1 R2014 for fatigue and burst pressure ratings.
Zinc-nickel plating standard for 1000-hour salt fog protection.
Only 3 pins of the Deutsch DT04-4P Connector are used. The 4th pin is unused. Please see pinout for reference.
Do not apply installation torque to the anodized aluminum motor housing.
This valve is CE compliant. It meets the requirements for RF Radiated Emissions (IEC 61000-6-4), Radiated Immunity (IEC 61000-4-3), and Magnetic Field Immunity (IEC 61000-4-8).
When torquing this cartridge into its cavity, a crow’s foot wrench or similar will be required since the motor housing precludes the use of a deep socket wrench.

Technical Data