Model: MBIGX

Ajuste fijo, proporción de pilotaje 4.5:1 , reactiva a la carga , control de carga válvula

Cavity: T-19A | Capacity:

Modelo

MBIGXLN

3-Port Non-vented, Fixed Setting

Factory Set

Seal Material

Material/Coating

Donde comprar

Technical Data

cavidad
T-19A
Series
4
Capacity
120 gpm
Maximum Operating Pressure
5000 psi
Pilot Ratio
4.5:1
Maximum Recommended Load Pressure
See Technical Features
Check Cracking Pressure
25 psi
Factory Pressure Settings Established at
2 in³/min.
Maximum Valve Leakage at Reseat
5 drops/min.
Reseat
≥77% of setting
Valve Hex Size
1 5/8 in.
Valve Installation Torque
350 - 375 lbf ft
Seal kit - Cartridge
Buna: 990-019-007
Seal kit - Cartridge
Polyurethane: 990-019-002
Seal kit - Cartridge
Viton: 990-019-006

Curvas de desempeño

CAD Files

Model CAD Files

Files not yet avialable. Click below to request them.

Preguntas frecuentes

Why is turning the adjust screw for counterbalance valves opposite of most other valves?
What parts of the Sun cartridge valve are field serviceable?
You say your valves leak 5 drops/min. How can I keep my load from drifting?
How do I determine the setting of a counterbalance valve?
How do I know how much pilot pressure is required to lower a load with a counterbalance valve?
When should I use a vented counterbalance valve?
How does Sun test a counterbalance valve for leakage?
How do I decide which pilot ratio to select?
How big is a drop of hydraulic oil?
Why can't I use a counterbalance valve in a closed loop transmission circuit?
What do you mean by the setting of a counterbalance valve and what should it be?
I don't need pilot assist. Can I just block port 3?
Can I use an atmospherically vented counterbalance valve instead of the four-port version to save on plumbing?
Why is it that your valves have pilot ratios below 10:1, while other manufacturers start at 7:1 and go up?
Why can't I block the pilot vent port? That area is positively sealed, isn't it?
Should I replace the counterbalance valve if my cylinder is drifting or moving?
I have a pilot-to-open check on a large cylinder and the decompression is violent. Can I use a counterbalance instead?
How do I size a counterbalance valve?
Can I adjust a counterbalance valve in the field?
Why do you offer 2 check valve cracking pressures?
What happens to the counterbalance valve if I have backpressure in my system?
What do you mean by hysteresis when referring to a counterbalance valve?